TC

If you can’t find the answer to your question either by using the search box or via the buttons, 

please call us on 01883 622778 or E-MAIL
Back     FAQ(s) in Category: Working with other Protocols   page 6 of 21  
< Previous | Next >
What is the set up for a 3AS to work with John Deer
Modified On 02/26/2010
 
-------------------------------------------------------------------------------
***** SATELLINE-3AS 3069 *****
SW version 3.21 / HW: uCE3/TC8k Ser. no nnnnnnnnn
-------------------------------------------------------------------------------
Current settings
----------------
1) Radio frequency 869.4125 MHz ( CF 869.01250 MHz, spacing 25 kHz )
2) Radio settings TX power 500 mW / Signal threshold -112 dBm / FCS OFF /
TX start delay 0ms / Diversity RX OFF / EPIC PWRSave OFF
3) Addressing RX address ON 0000/0000 / TX address ON 0000/0000 /
RX address to RS port OFF / TX address autoswitch OFF
4) Serial port 1 ON / 19200 bit/s / 8 bit data / None parity /
1 stop bit
5) Serial port 2 OFF / 19200 bit/s / 8 bit data / None parity /
1 stop bit ( RS-232 )
6) Handshaking CTS Clear to send / CD RSSI-threshold / RTS Ignored
7) Additional setup Error correction OFF / Error check OFF / Repeater OFF /
SL-commands ON / Priority TX
8) Routing OFF
9) Tests OFF
A) Restore factory settings
E) EXIT and save settings
Q) QUIT without saving
Enter selection >
Notes:
• Frequency limits:
o Low limit of band 1 and band 2 = 869.4125 MHz
o High limit of band 1 and band 2 = 869.6375 MHz
• TxPriority must be used (because the modem must transmit exactly when it is supposed)
• The only difference between the setups of a base, a repeater and a rover is that a repeater must
have the RepeaterFunction set ON. A base and a rover must have the RepeaterFunction OFF.
• Software version 3.21 is to be used as fas as possible (ROHS duable changes possible).
• Product number to be programmed in the modem is "JD3AS869".
• Standard Satel serial number is programmed in the modem.
All Categories (21)
 
Networking (2)
Designing and planning a network
 
Software (4)
Programming software
 
Antennas & Range (3)
 
Working with other Protocols (4)
 
Ordering (1)
 
Frequencies (2)
 
Troubleshooting (3)
What do check if it is not going to plan!
 
Certifications (0)
 
Compatibility (0)
 
Manuals (0)
 

This site uses Adobe .pdf files for more information go to www.adobe.com